Auto-Cad version 2002 with a Mastership module is utilized in design, shaping and pre-fabrication of steel CAD CAM sections, allowing for the highest accuracy in plate cutting. To warrant this quality, the CAD CAM system is connected to 2 fully automated ESAB burning machines by means of a PCI system.

Covered shop area :		2,500m2 / 26,900 sq. ft.
Covered assembly floor :		45 x 18 m / 148' x 59'
Cranes :		2 x 30 ton overhead traveling cranes; lifting height 9m / 30'
Prefabrication capacity :		Sections up to 60 tons with overhead cranes; heavier sections up to approximately 95 tons with additional mobile cranes.

2x Automatic CNC machines / NC 510 Telerex and NC 280 Picorex
		Cutting Heads		Pit		Width at Carriage		Length of Travel		Plate Thickness
NC 510 Telerex		4		8		8 m / 26'		25 m / 82'		200 mm / 8"
NC 280 Picorex		2		2		2.5 m / 5'		6 m / 20'		200 mm / 8"
Plasma		1		1		2.5 m / 5'		6 m / 20'		200 mm / 8"

• Portable Plasma cutting machines (max. 200) connected with NC 280 machine. Cutting up to 50 mm on various materials,

• Plasma Arc Cutting with hand Torch (PCM-102). Cut Quality on variious materials up to 25.4 mm

• Hydraulic plate press 300 tons width. Inside frame 5.90 m / 19.4" 2 cranes, 3.2 tons each
• Hydraulic frame bending press 300 tons. Maximum capacity 2 frames simultaneously; 350 mm x 30 mm / 13 3/4" x 1 3/16"
• Plate shears. Maximum plate thickness 14 mm Maximum width 2500 / 98"
• Electr./Hydr. CNC-Press Brake. Press Pressure: 250 ton Work Length: 4050 mm Rate thickness: 0,5 up till 20 mm
• Plate bending rolls. Maximum width For plate thickness 20 mm / 3/4", 500 mm / 20" For plate thickness 12 mm /'/2", 2500 mm / 98" For plate thickness 16 mm / s/8", 6000 mm / 236"

Portable arc and plasma gouging units




Automatic and semi-automatic processes
• Submerged arc units up to 2000 Amps (S.A.W.)
• TIG units (Argon arc / G.TTA.W.)
• MIG units (C02 / G.M.A.W. / FFC.A.W.)
• SIGMA welding

Manual welding
• AC and DC units
• 18 ton welding manipulator
• Equipment for one sided (brick-backed) welding
• Portable X-ray equipment (testing of welds)
• Shielded metal-arc welding (stick) electrodes

Pre-heating and post-heating of welded pipework, vessels and structures can be heated to temperatures Annealing up to 1050 °C. Thermo-couple attachments for constant temperature control and registry.

Ultrasonic thickness measurements
Audio gauging performed by "Wilson Walton International" as independent specialists: reports accepted by all classification societies. Normally no staging required: up to 100 measurements per hour, if required, surveys can be carried out during voyage.